Menu
The Bose 502C systems controller is a single rack space device which provides dual channel cross-over and active electronic equalization for both the 502A and 502B. I'm new to this equip. I bought the system used and did not come with any manual on the controller hook up, i use a powerd mixer to drive the 802's, and like to hook up the controller, unfortunately, i don't have a clue on how 2 do this. Anybody out there that might know or can direct me 2 a site that might b able 2 help me. Similar manuals: BOSE COMPANION 3 BOSE COMPANION 5 BOSE COMPANION 5 SPEAKER SYSTEM SERVICE BOSE CONTROLSPACE ESP-88C ESP-00 SOUND-PROCESSORS CC-16 CC-64 BOSE FREESPACE-6-BUSINESS-MUSIC-CENTER. If you want to join us and get repairing help please sign in or sign up by completing a simple electrical test.
Applies to:
Bose 502c System Controller User Manual Instructions
These CAUTION marks may be located on the back of the PANARAY® System Digital Controller. The lightning flash with arrowhead symbol, within an equilateral trian-gle, is intended to alert the user to the presence of uninsulated danger-ous voltage within the system enclosure that may be of sufficient mag-nitude to constitute a risk of electric.
Be sure the system turns on. Try turning on the system using the control panel. If the control panel does not work, see My system will not turn on
Install new batteries in the remote. Be sure the batteries, including those recently installed, match the polarity markings inside the battery compartment. Do not use rechargeable batteries. Rechargeable batteries may not charge fully after extended use, and some may have a lower voltage output
on the control console, press and hold power for five seconds. the red led will turn off
Reassociate the remote with the system. The media center and remote must match for proper operation. For information on reassociating the system and remote, see Pairing the remote control with the console
There's a 'No signal' message displayed on my remote. What should I do?
If the display on the remote control shows 'No Signal,' try Pairing the remote control with the console and Resetting the control console to resolve this issue